Shermanlevel2.0 not working

[GRT 0]

on my map i made some stairs going to a roof top and added a shermanlevel2.0(it is marked in the map editor also) its in the middle right under shermanlevel1.0 but when i go into igor it says levels 1 of 1 up in the corner..do i have to add something to it or the building to show that i want it to be on level 2

[San 0]

I think you need to make a roomlist.txt or something and put rooms and shermanlevels in there.

But better wait for an expert's advise

[hartog 0]

I did the same thing

you have to have it in the roomlist.txt file so it looks like this

room 1 levels 1.0 end end

room 1 levels 2.0 end end

room 1 levels 3.0 end end

then it will show in IGOR.

[GRT 0]

ok i added that to the .txt and pressed enter after it also..loaded GR and it still says Level 1 of 1.. ...do i have to add something to the geometrey

[cobaka 0]

I assume you have shermanlevelheight1.0 and shermanlevelheight2.0? Your shermanlevels should be named shermanlevelxx_1.0 or shermanlevelxx_2.0 where xx is the room number. You can also have shermanlevelxx_1.5stairs for stairs tagged as being on both level 1 and 2.

Also in your roomlist, you can have the levels on one line:

room 1 levels 1.0 2.0 end end

[GRT 0]

I assume you have shermanlevelheight1.0 and shermanlevelheight2.0?

Yes

Your shermanlevels should be named shermanlevelxx_1.0 or shermanlevelxx_2.0 where xx is the room number.You can also have shermanlevelxx_1.5stairs for stairs tagged as being on both level 1 and 2.

The only shermanlevels i had was shermanlevel01_1.5 and shermantransistion01_1.25 and 1.75

Also in your roomlist, you can have the levels on one line:

room 1 levels 1.0 2.0 end end

my roomlist.txt is set up like this

room 1 levels 1.0 end end

room 1 levels 1.0 2.0 end end

room 1 levels 2.0 end end

Do i need to add anthing more to that

*EDIT* ok i used javamans new smarttools and i exported my roomlist from there..the only thing it put was

room 01 levels 0.0 1.0 2.0 end end

thats it

Edited November 13, 2003 by IF_GRT

[cobaka 0]

If you use shermanlevels, use must have shermanlevels on level 1 and level 2 as well as inbetween (level 1.5). If you only have one map level, you don't need shermanlevels.