Siveres Posted December 24, 2012 Share Posted December 24, 2012 Dear Community, after i start the first mission in Ghost Recon:2 Advanced Warfighter 2, the map is loading. On the next screen with a introduction of the mission the screen is freezed and i cant move the cursor or do anything else, after 5 seconds i always get the following failure message: Error in Applicxation Crash in application version: 30899.3048 Unhandled exception - -529697949 C STACK: KERNELBASE (???) : RaiseException graw2 (???) : ??? graw2 (???) : ??? graw2 (???) : ??? graw2 (???) : ??? graw2 (???) : ??? PhysXCore (???) : NfCreateCoreSDK PhysXCore (???) : NfCreateCoreSDK PhysXCore (???) : AgPmEventLoggingEnabled PhysXCore (???) : NfCreateCoreSDK graw2 (???) : ??? PhysXCore (???) : AgPmEventLoggingEnabled PhysXCore (???) : NfCreateCoreSDK Renderer: threaded Physics : threaded ive seen other threads with the same failure message, but they didnt have the same problems LG Rad Quote Link to comment Share on other sites More sharing options...
JohnTC02 Posted December 24, 2012 Share Posted December 24, 2012 Hi Siveres, Welcome to the forums. I'm suspecting that your system is struggling to cope with the resources needed to run the game. First thing you can try is to lower (or turn off) the Physics settings, if that doesn't help try reducing the texture and Dynamic Shadows. Lastly did you install the Physics drivers when you installed the game, these are needed for the game to run. Quote Link to comment Share on other sites More sharing options...
Siveres Posted December 24, 2012 Author Share Posted December 24, 2012 (edited) thanks for the early answer on christmas, then its the physics driver, i had a little problem with this, where can i get it and try to install it again Edited December 24, 2012 by Siveres Quote Link to comment Share on other sites More sharing options...
JohnTC02 Posted December 24, 2012 Share Posted December 24, 2012 Your best bet is to reinstall the game, the physics driver is part of the game installation. It's been a while since I installed the game but I think you are asked after the game is installed if you want to install the Ageia/PhysX driver, you must do this for the game to work correctly. Quote Link to comment Share on other sites More sharing options...
Tinker Posted December 24, 2012 Share Posted December 24, 2012 The physics driver installer is in the game folders somewhere if I remember correct. Not able to check. Quote Link to comment Share on other sites More sharing options...
JohnTC02 Posted December 24, 2012 Share Posted December 24, 2012 For me it's on the install DVD, look in Support/Ageia the filename is PhysX_7.05.17_SystemSoftware running that sould install the physics drivers. Quote Link to comment Share on other sites More sharing options...
Siveres Posted December 24, 2012 Author Share Posted December 24, 2012 kk thx iwill do this Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.